ASTM D Standard Test Method for Ball-Pan Hardness of Activated Carbon. Standard Test Method for Ball-Pan Hardness of Activated Carbon. Status: Withdrawn · Replaced by: ASTM D Buy this standard. Price: SEK. PDF. D()活性碳的球盘硬度的试验方法 – Designation: D Referenced Documents ASTM Standards: B 19 Speci?cation for.

Author: Moogugami Kazijinn
Country: Samoa
Language: English (Spanish)
Genre: Automotive
Published (Last): 13 March 2006
Pages: 358
PDF File Size: 17.2 Mb
ePub File Size: 11.68 Mb
ISBN: 327-6-35416-529-6
Downloads: 66958
Price: Free* [*Free Regsitration Required]
Uploader: Shazahn

Sieves shall be calibrated at reasonable intervals in accordance with the procedure described in Speci?

ASTM D3802 – 16

BoxGastonia, NChas been found to be satisfactory. Humidity effects during a given test will largely astk out if no change in humidity occurs between 9. Summary of Test Method 4.

If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address shown below. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

A superscript epsilon e indicates an editorial change since the last revision or reapproval.

Fit the cover plate with a cork stopper which extends from 3. Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or at phonefaxor service astm.


The extra sieves, in this case, serve only to form a stack which? Conceding the fact that the test does not actually measure in-service resistance to degradation, it can be used to establish the comparability of lots ostensibly of the same grade of carbon.

Standard Test Method for Ball-Pan Hardness of Activated Carbon

Tyler Model SB, available from W. Weigh to the nearest 0. Obtain at least mL of material within the nominal mesh size range. Precision and Bias This standard is subject to revision at any time by the responsible technical committee and must be reviewed every?

Standard – Standard Test Method for Ball-Pan Hardness of Activated Carbon ASTM D –

Apparatus and Materials 6. Table 1 lists the hardness test sieve corresponding to each minimum nominal sieve. Current edition approved June 29, Pour the screened and weighed sample into the hardness pan and add the steel balls. Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend.

Adjust the bottom stops to give a clearance of approximately 1. Use additional material obtained as in 9. One supplier tested 31 samples of a single grade of carbon and obtained an average hardness of None of these has proved completely satisfactory for all applications, and all have been questioned by ASTM Committee D on Activated Carbon as tests for establishing degradation resistance.


The adhesion of material to sieves, brushes, etc. Shake with the hammer operating for astn min 6 xstm s. Place the hardness test sieve on top of the receiving pan. Discard the fractions above the larger and below the smaller nominal particle size. The value of H2 gives the d382 limit of hardness, if we ignore the effects of humidity.

ASTM D – 16 Standard Test Method for Ball-Pan Hardness of Activated Carbon

Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility. A number in parentheses indicates the year of last reapproval.

Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Headquarters. At the end of this period, the amount of particle size degradation is determined by measuring the quantity of carbon, by weight, which is retained on a sieve whose openings are closest to one half the openings of the sieve that de?